Black Horse Model BH174, Инструкция по эксплуатации

Страница: 21 / 51

SBACH 342 Item code: BH174 Instruction Manual
Cut off shaded portion Apply epoxy glue
90 Degree
The rudder is controlled by two metal cables. Install
the rudder linkages and cables as below.
1. Use a hobby knife to remove the covering from
the openings for the rudder control cables.
2. The rudder has a block wood plate for mounting the
control horn. Two control horn in positioned on
both side rudder (left and right).
3. Install the control horn to the rudder.
4. Slide a crimp onto the cable, then pass the cable
through the threaded cable end. Pass the cable
back into the crimp and use crimping pliers to
secure the crimp to the cable. Guide the cable
into the fuselage to the position for the rudder
servo.
5. Thread the metal connector to the link ball.
6. Center the rudder servo using the radio and install
the servo arm. Attach the plastic link ball to the
rudder servo arm.
7. Slide a crimp onto the cable, then pass the cable
through the threaded cable end. Pass the cable
back into the crimp and use crimping pliers to
secure the crimp to the cable.
9. Attach the clevis to the rudder servo. There should be
light tension on each of the wires when installed
properly.
Note: Remember use thread locking compound to
secure.
4
4
1100mm Cable rod
3 x 30mm Connector
Locknut
3 x 12mm Screw
2
2
4
Aluminum ball
2
4
3mm Washer
2
1
3 x 35mm Cap Screw
INSTALLING THE RUDDER LINKAGES
RUDDER INSTALLATION
21
- - - - 5
Pinned Hinge
Pinned Hinge
< Top view >