Secure
1)
Cut out the switch hole using a modeling knife.
Use a 2mm drill bit and drill out the two mounting
holes through the fuselage side.
2)
Secure the switch in place using the two machine
screws provided with the radio system.
3)
Plug the servo leads and the switch lead into the
receiver. You may want to plug an aileron extension
into the receiver to make plugging in the aileron
servo lead easier when you are installing the wing.
Plug the battery pack lead into the switch.
MXS Item code: BH167
INSTALLING THE SWITCH, RECEIVER AND BATTERY
4)
Wrap the receiver and battery pack in the
protective foam to protect them from vibration. Use a
rubber band or masking tape to hold the foam in
place.
5)
Position the battery pack and receiver behind the
fuel tank. Use two tie wraps to hold the battery and
receiver securely in place as pictures below.
Do not permanently secure the receiver and battery
until after balancing the model.
6)
Using a 2mm drill bit, drill a hole through the side
of the fuselage, near the receiver, for the antenna to
exit.
22