17
SPEED AIR-40 _
Item code:BH08-A.
Instruction Manual.
o
2) Using a ruler and a pen, locate the
centerline of the horizontal stabilizer, at the trail-
ing edge, and place a mark. Use a traingle and
extend this mark, from back to front, across
the top of the stabilizer. Also extend this mark
down the back of the trailing edge of the stabi-
lizer. Then slide the horizontal stabilizerthe into
the fuselage.
3
1. Using a modeling knife, cut away the
covering from the fuselage for the stabilizer
and remove it.
Remove covering.
Check to mark sure the wing and stabi-
lizer are paralell. If they are not, lightly sand
the opening in the fuselage for the stabilizer
until the stabilizer is paralell to the wing.
Center line.
1
4. Remove the stabilizer. Using the lines
you just drew as a guide, carefully remove the
covering from between them using a modeling
knife.
3
3. With the stabilizer held firmly in place,
use a pen and draw lines onto the stabilizer
where it and the fuselage sides meet. Do this
on both the right and left sides and top and
bottom of the stabilizer.
Mark pen
Remove
covering.