8
REPAIR AND MAINTENANCE
• Do not operate the log splitter when it is in poor mechanical
condition or in need of repair.
Frequently check that all nuts, bolts,
screws, hydraulic fittings and hose clamps are tight.
• Do not
alter the log splitter in any manner. Any alteration will void
the warranty and could cause the log splitter to be unsafe to operate.
Perform all recommended maintenance procedures before using the
log splitter. Replace all damaged or worn parts immediately.
• Do not
tamper with the engine to run it at excessive speeds. The
maximum engine speed is preset by the manufacturer and is within
safety limits. See Kohler engine manual.
•
Remove the spark plug wire before performing any service or repair
on the log splitter.
• Always check the level of hydraulic oil and engine oil
before operation.
•
Replacement parts must meet manufacturer’s specifications.
HYDRAULIC SAFETY
The hydraulic system of the log splitter requires careful inspection along
with the mechanical parts. Be sure to replace frayed, kinked, cracked or
otherwise damaged hydraulic hoses or hydraulic components.
• Check for hydraulic fluid leaks
by passing a piece of paper or
cardboard underneath or over the area of the leak.
Do not check
for leaks with your hand
Fluid escaping from the smallest hole,
under pressure, can have enough force to penetrate the skin causing
serious injury or death.
.
• Seek professional medical attention immediately if injured
by
escaping hydraulic fluid
. Serious infection or reaction can develop if
medical treatment is not administered immediately.
•
Relieve all pressure by shutting off the engine and moving the valve
control handle back and forth should it become necessary to loosen
or remove any hydraulic fitting.
• Do not
remove the cap from the hydraulic tank or reservoir while the
log splitter is running. The tank could contain hot oil under pressure
which could result in serious injury.
• Do not
adjust the hydraulic valve. The pressure relief valve on the
log splitter is preset at the factory. Only a qualified service technician
should perform this adjustment.
WARNING
!
IMPORTANT SAFETY INFORMATION
