Black + Decker BEHT200, Инструкция по эксплуатации

Страница: 8 / 32

English
6
Always hold the trimmer, as shown in Fig. G, with one
hand on the switch handle and one hand on the bail
handle. Never hold the tool by the blade guard.
Fig. H
3. TRiMMing nEW gROWTh– (Fig. i) – A wide,
sweeping motion, feeding the blade teeth through the
twigs is most effective. A slight downward tilt of the
blade, in the direction of motion gives the best cutting.
CAUTION:
Do not use trimmers for cutting
stems greater than 3/4 in. (19 mm). (Do not use
BEHT200 trimmer for cutting stems greater
than 5/8 in. (16 mm)).
Use the trimmer only for
cutting normal shrubbery found around houses
and buildings.
Fig. I
4. lEVEl hEDgEs (Fig. J) – To obtain exceptionally level
hedges, a piece of string can be stretched along the
length of the hedge as a guide.
Fig. J
5. siDE-TRiMMing hEDgEs (Fig. K) – Begin at the
bottom and sweep up.
Fig. K
6.
saw
BlADE™ (Fig. l) (BEHTS300, BEHTS400) – For
branches too large for the blade 1 to cut, use the
saw
BLADE™
8
. Position the
saw
BLADE™ as close
to the bottom of the branch as possible. Place the
saw
BLADE™ shoe
9
against the branch. Turn the
hedge trimmer on as described above, allowing the tool
to work at its own pace until the branch is fully cut.
Fig. L
1
8
9
WARNING:
TO GUARD AGAINST INJURY,
OBSERVE THE FOLLOWING:
• READ INSTRUCTION MANUAL BEFORE USING,
SAVE INSTRUCTION MANUAL.
• CHECK THE HEDGE FOR FOREIGN OBJECTS SUCH
AS WIRE OR FENCES BEFORE EACH USE.
• KEEP HANDS ON HANDLES. DON’T OVERREACH.
• DO NOT USE UNDER WET CONDITIONS.
• DO NOT USE WITH DAMAGED EXTENSION CORD.
DANGER:
KEEP HANDS AWAY
FROM BLADES.
CAUTION:
BLADE COASTS AFTER
TURN OFF.
MAINTENANCE
WARNING:
Remove extension cord
from trimmer before servicing, cleaning or removing
material from the gardening appliance.
The cutting blades are made from Fig. M
high quality, hardened steel and
with normal usage, they will not
require resharpening. However, if
you accidentally hit a wire fence
(Fig. M), stones, glass or other hard
objects, you may put a nick in the
blade. There is no need to remove
this nick as long as it does not
interfere with the movement of the
blade. If it does interfere, unplug
the cord and use a fine toothed file or sharpening stone to
remove the nick. If you drop the trimmer, carefully inspect it
for damage. If the blade is bent, housing cracked, or handles
broken or if you see any other condition that may affect the
trimmer’s operation contact your local BLACK+DECKER
Service Center for repairs before putting it back into use.