Black+Decker MT280, Оригинальное руководство пользователя

Страница: 10 / 76

10
ENGLISH
(Original instructions)
• Firmly attach the fixing bolt (7) into
place to ensure a tight fit for the
alternative accessory (11).
Note: The spacer and fixing bolt are not
used to attach BLACK+DECKER
accessories. BLACK+DECKER accessories
are attached using the Super-lokTM Tool
free accessory clamping lever.
Use
Warning! Let the tool work at its own pace.
Do not overload.
Warning!
Before cutting into walls, floors or
ceilings, check for the location of wiring and
pipes.
Variable speed control (fig. G)
The variable speed control allows you to
adapt the speed of the tool to the
application.
• Set the variable speed dial (2) to the
desired setting. At setting 1 the tool will
operate at low speed, 10,000 min-1. At
setting 6 the tool will operate at the
maximum speed, 22,000 min-1.
Switching on and off (fig. H)
• To switch the tool on, slide the on/off
switch (1) forward (position I).
• To switch the tool off, slide the on/off
switch (1) to the rear (position O).
Hints for optimum use
• Always hold the tool securely. For
precision work, hold the tool near the
front.
• Clamp the workpiece whenever possible,
especially when using cutting blades.
• Do not exert too much pressure on the
tool.
• Always use the appropriate type of
attachment for the workpiece material
and type of cut.
• Regularly check the condition of
accessories. Replace when necessary.
• Mark the desired starting point.
• Switch the tool on and slowly feed
attachments into the workpiece at the
desired starting point.
• Clamp a piece of plywood or soft wood
to the back of the workpiece and saw
through the combination in order to
obtain a clear cut.
• Do not force the cutting blade into the
workpiece. Note that cutting sheet metal
will normally take more time than sawing
thicker wooden workpieces.
• When cutting metal spread a thin film of
oil along the cutting line before cutting.
• When sanding new layers of paint before
applying another layer, use extra fine grit.
• On very uneven surfaces, or when
removing layers of paint, start with a
coarse grit. On other surfaces, start with a
medium grit. In both cases, gradually
change to a fine grit for a smooth finish.
• Consult your retailer for more information
on available accessories.
Maintenance
Your BLACK+DECKER corded/cordless
appliance/tool has been designed to operate
over a long period of time with a minimum
of maintenance. Continuous satisfactory
operation depends upon proper tool care
and regular cleaning.
Warning!
Before performing any
maintenance on corded/cordless power
tools:
• Switch off and unplug the appliance/tool.
• Or switch off and remove the battery
from the appliance/tool if the
appliance/tool has a separate battery
pack.
• Or run the battery down completely if it is
integral and then switch off.
• Regularly clean the ventilation slots in
your appliance/tool/charger using a soft
brush or dry cloth.
• Regularly clean the motor housing using
a damp cloth. Do not use any abrasive or
solvent-based cleaner.