5
• Rotate the locking ring (3) counterclockwise to
release the clips.
• Pull the hose away from the handle.
• Fit the accessory directly to the hose cuff (20).
To refit the handle:
• Remove the accessory from the hose.
• Push the hose into the handle (2). Rotate locking
ring (3) clockwise until it clicks into place.
ASSEMBLING FLOOR HEAD (FIGURE E)
(BDH2020FLFH ONLY)
This vacuum is equipped with a floor head for wider
floor cleaning.
• Press and hold the accessory clip (11).
• Slide the floor head adapter (17) onto the handle
(2).
• Connect the two floor head extensions (18), extension
connector (19), and the floor head (20) to the end for the
floor head adaptor.
NOTE:
The floor head attaches using friction fitting, so a
click will not be heard when assembled. Ensure that all
parts of the floor head assembly are securely connected.
CARPET / FLOORING SELECTOR SWITCH (FIGURE F)
The floor head’s agitator brush can be used for light carpet
cleaning and removing tough messes on hard floors. It can
be activated by depressing the selector switch (21) located
on the top of the floor head accessory.
• To engage the agitator brush, depress the side of the
selector switch marked
.
• To disengage the brush, depress the side of the selector
switch marked
.
OPERATION
Before first use, the batteries must be charged for at
least 4 hours.
• Connect the appliance to the charger for a minimum of
4 hours.
• Charge the batteries as described below.
CHARGING THE BATTERY (FIGURE G)
WARNING:
Charge only at ambient temperatures between 50°F (10°C)
and 104°F (40°C). The charger supplied with this product is
intended to be plugged in such that it is correctly oriented in
floor mount position.
To charge the appliance:
• Make sure the appliance is switched off. The battery will not
be charged with the on/off power switch (1) in the on position.
• Plug the charging base (15) into a standard 120 Volt 60
Hz electrical outlet.
• Lower the appliance onto the charging base. The
charging indicator LED will illuminate.
• When charging is complete, the LED will turn off.
While charging, the charger may become warm. This is
normal and does not indicate a problem.
Leaving the appliance connected to the charger indefinitely
will not damage the appliance’s batteries or shorten
its run time. The charger automatically reduces power
consumption when charging is complete.
D
2
13
20
20
F
21
G
15
6
E
20
17
18
11
19
