8
WARNING!
OPERATING INSTRUCTIONS
ASSEMBLY
To reduce the risk of fire or explosion, do not operate this vacuum in areas with flammable
gases, vapors or explosive dust in the air. Flammable gases or vapors include but are
not limited to: lighter fluid, solvent-type cleaners, oil-based paints, gasoline, alcohol or
aerosol sprays. Explosive dusts include but are not limited to: coal, magnesium,
aluminum, and grain or gun powder. Do not vacuum explosive dust, flammable or
combustible liquids or hot ashes. Do not use this vacuum as a sprayer for any flammable
or combustible liquid. To reduce the risk of health hazards from vapors or dusts, do
not vacuum toxic materials.
CAUTION:
To reduce risk of hearing damage, wear ear protectors when using the vacuum for
extended hours or when using it in a noisy area.This 15 Litre wet/dry vacuum is assembled
at the factory and ready for use when you remove it from the carton. The unit is ready for
dry vacuuming or blowing. After you plug the power cord into the wall receptacle, turn
the unit “ON” by pushing the switch from position “O” to position “I”.
The “O” is the “OFF” position and the “I” is the “ON” position.
INSTALLING HANDLE
To install handle
1. Place handle in recess (3)
2. Insert provided screws (1)
3. Use Phillips screwdriver to secure and tighten.
INSTALLING CASTERS
Use provided casters and insert into the bottom
of caster dolly as shown in Figure (A). Strong
pressure required and listen for the click to ensure
locked in place.
Figure (A)
O = OFF I = ON
(1)
(2)
(3)
(1)
(2)
(3)
DRY PICK-UP
1. The foam filter and reusable dry filter may be used to pick up dust and dry material;
you must install both to ensure proper filtration. lf the vacuum has been used to pick
up liquids, the foam filter must be cleaned and dried before installing for dry pick up.
