Black Box SW621A-R3, Руководство пользователя

Страница: 26 / 45

CHAPTER 4: OPERATION
25
Command Keystroke Sequence Description
Stop Scanning [Ctrl] X Turns Scan mode OFF (the port being scanned at
the time the command is entered is given access
to the shared monitor, keyboard, and mouse).
Note: Scan can also be stopped by entering a
Select Port command.
Perform
Standard
Reset [Ctrl] R Resets and enables the keyboard and mouse.
Issue this command to correct your keyboard or
mouse if one of them malfunctions or gets stuck.
Send Null Byte [Ctrl] N Causes the ServSwitch Jr. to send a null byte to
the CPU’s PS/2 mouse port. Issue this command
to correct the current CPU if it gets “out of sync”
with the PS/2 mouse (see
Section 4.3.5 ).
Reset Recent
Windows
Mouse Driver [Ctrl] O Sends a command to the currently selected CPU
that will cause a mouse-driver reset if the CPU is
running certain combinations of recent Windows
OS and recent mouse driver.
Identify ROM [Ctrl] I Causes the ServSwitch Jr. to report the version of
ROM it is using. Issue this command if you are
asked to do so by a technical-support person.
Keep
Settings
[Ctrl] K Enter this command after you enter any of the
five commands listed below (it saves new settings
to nonvolatile memory):
Set Maximum
Number of
Ports [Ctrl] P x [ENTER]
( x = 2 to 7)
SW622A-R3, SW629A-R2 only: Tells the Switch
the total number of ports to which devices are (or
will be) connected. Issue this command when
you’re not using all of your unit’s ports.
Set Scan-
Delay Time [Ctrl] T xx [ENTER]
( xx = 1 to 15)
Sets the time, in seconds, that the ServSwitch Jr.
will pause at each port when scanning.
Set Keyboard
Mode [Ctrl] M x [ENTER]
( x = 1, 2, or 3)
Tells the ServSwitch Jr. the keyboard mode (1, 2,
or 3) of the currently selected CPU.
Set Keyboard
Typematic [Ctrl] A xxx [ENTER]
( xxx = decimal value
from 0 to 127)
Sets the keyboard typematic (automatic keyrepeat)
function of the currently selected CPU.
This command works only with CPUs that have
standard keyboards and CMOS that allows users
to program the typematic function.
Set Mouse
Mode
[Ctrl] Q x [ENTER]
( x = 0, 1, or 2)
Q1 turns on PS/2 to RS-232 mouse translation for
the selected CPU. Q2 forces PS/2 wheel-mouse
output to the selected CPU. Q0 turns these off.