Black Box ServSelect IP KV120A, Руководство пользователя

Страница: 30 / 48

SERVSELECT™ IP INSTALLER/USER GUIDE
28
CHAPTER 4: ANALOG PORT OPERATION
29
3. In the Repeat box, type the password again and press
Enter
.
4. Click OK to change only your password, and then close the dialog box.
NOTE:
If you should lose or forget your password, you must return your ServSelect IP.
To password protect your console:
1. Set your password as described in the previous procedure.
2. Select
Enable Screen Saver.
3. Type the number of minutes for Inactivity Time (from 1 to 99) to delay
activation of password protection and the screen saver feature.
4. For Mode, select Energy if your monitor is E
NERGY
S
TAR
®
compliant; otherwise
select Screen .
CAUTION:
Monitor damage can result from using Energy mode with monitors not compliant with E
NERGY
S
TAR
.
5. (Optional) Click Test to activate the screen saver test which lasts 10 seconds
then returns you to the Security dialog box.
6. Click OK .
To log in to your console:
1. Press any key or move the mouse.
2. The Password dialog box appears. Type your password, then click
OK .
3. The Main dialog box appears if the password was entered properly.
To remove password protection from your console:
1. From the Main dialog box, click Setup - Security ; the Password dialog box
appears. Type your password, then click OK .
2. In the Security dialog box, single-click and press
Enter
or double-click in the
New box. Leave the box blank. Press
Enter
.
3. Single-click and press
Enter
or double-click in the Repeat box. Leave the box
blank. Press
Enter
.
4. Click OK to eliminate your password.
To enable the screen saver mode with no password protection:
1. If your console does not require a password to gain access to the Security dialog
box, proceed to step 2.
-or-