19
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.877.877.2269
1.877.877.2269
BLACKBOX.COM
CHAPTER 3: INSTALLATION
3.1 WALLMOUNTING INSTRUCTIONS
3.1.1 TOOLS LIST
Power Drill with 7/16” Socket
Level
Stud-Finder (optional)
3.1.2 INSTRUCTIONS
STEP 1: Locate wall studs for mounting low profile wallmount cabinet and determine if they are spaced 16” or 19” apart
to determine the correct mounting holes to use.
STEP 2: Mark mounting hole placement on wall for the top mounting holes in the cabinet. Cabinet should be mounted
into the middle of wall studs – mounting holes will be either 16” or 19” apart depending on the spacing of the wall studs.
Use the level to make sure the holes will be at the same height.
STEP 3: Use the drill to drive ONE (1) ¼”-10 X 2” LAG SCREW FOR WOOD with ONE (1) ¼” LOCK WASHER and ONE (1) ¼” FLAT
WASHER approximately ¾ of the way into the first marked mounting hole.
STEP 4: Repeat step (3), driving ONE (1) ¼”-10 X 2” LAG SCREW FOR WOOD with ONE (1) ¼” LOCK WASHER and ONE (1) ¼” FLAT
WASHER approximately ¾ of the way into the second marked mounting hole.
STEP 5: Place low profile wallmount cabinet onto these TWO (2) mounting screws. The ¼” FLAT WASHER and ¼” LOCK WASHER
should be inside the cabinet (see picture). Make sure the cabinet rests all the way down with the mounting screws sitting
in the narrow part of both the top mounting holes. Check that cabinet is level before tightening top mounting screws
STEP 6: Once cabinet is positioned correctly on the top TWO (2) mounting screws and is level, use the drill to tighten
both mounting screws into the wall.
STEP 7: Complete wall mounting the low profile cabinet by driving the remaining TWO (2) ¼”-10 X 2” LAG SCREWS FOR WOOD,
TWO (2) ¼” LOCK WASHERS, and TWO (2) ¼” FLAT WASHERS into the correctly spaced bottom mounting holes in the cabinet.
FIGURE 3-1. MOUNTING THE RMT351A CABINET ON THE WALL
NOTE: Instructions for mounting
the cabinet on the wall
are the same for all models.
