
INSTALLATION
21
3.3 System Setup
To install your RGB to DVI(/VGA) Converter:
1.
Switch off all devices.
2.
Connect your TFT directly to the device; connect a VGA screen by using the equipped
DVI-I to VGA adapter.
Attention: Connect the VGA monitor cable to the adapter; then plug in
the adapter into the device. Otherwise, the VGA mode is not detected,
DVI output is generated and there will be no picture on the screen (see
also Diagnostic LEDs on page 24).
Under some circumstances, if your TFT supports both DVI and VGA
through a DVI-I cable, it might be necessary to use an additional DVI-
I to DVI-D adaptor to get a DVI output. Please contact technical
support for this accessory.
3.
RGB:
Connect the graphic source to the input connectors as shown in Figure 14, using
the equipped 4xBNC-to-DVI adaptor. Please note, for connecting a CGA or EGA
source, connect the optional CGA-to-DVI adaptor or EGA-to-DVI adaptor instead of the
4x BNC-to-DVI adaptor.
VGA:
Connect the graphic source to the input connectors as shown in Figure 4 using the
VGA to DVI-I Cable which is an optional feature.
TTL:
Connect the graphic source to the input connectors as shown in Figure 14, using
the equipped Data Cable DSUB9male- DSUB9female.
4.
Connect the 6V power supply to power the unit.
Only use the power supply originally supplied with this
equipment or a manufacturer-approved replacement.
5.
Power up the system.
Содержание RGB/EGA/CGA/MDA to DVI(/VGA) Converter
Страница 1: ...ACU315A R2 RGB EGA CGA MDA to DVI VGA Converter Manual http www blackbox com...
Страница 4: ...RGB EGA CGA MDA TO DVI VGA CONVERTER 4...
Страница 46: ...RGB EGA CGA MDA TO DVI VGA CONVERTER 46 The kit allows you to mount a different count of devices 1 4 devices...
Страница 57: ...NOTES...