FlexPoint T1/E1 Copper to Fiber Line Driver
User Instructions
Description:
The FlexPoint T1/E1 connects T1 and E1 devices, such as PBXs, CSUs and routers, via
Multimode (MM) or single-mode (SM) fiber. Designed to extend the standard T1/E1
twisted pair or Coax network distances over fiber, this converter provides protection from
environmental noise and effectively increases high-speed network reliability. The
following models are described here.
Model #:
Fiber Type:
Max Distance:
MT660A-MM MM,ST,1300nm 5km / 3.1mi
MT661A-SM
SM, ST, 1300nm
28km / 16.8mi
MT660A-MM-E MM,ST, 1300nm 5km / 3.1mi
MT661A-SM-E
SM, ST, 1300nm
28km / 16.8mi
Power Adapter Notice:
1. When using in a stand-alone configuration, this product is intended to be and must
be used only with a Listed Direct Plug-In Power Unit marked “Class 2” and rated
at 9VDC, 1 Amp.
2. This product should always be used only with the supplied power unit.
3. Models shipped with international power supplies are capable of auto switching
form 100-230VAC, and are supplied with a U.S. type NEMA 5-15 power cable.
4. For products being shipped outside of the U.S., the user is required to install a
properly grounded IEC 320 appliance cable with a minimum rating of 10 AMPs.
5. User-supplied cables must meet the required safety agency approvals, applicable
international standards and electrical ratings for the region.
Warning!
Before inserting the Power Adapter, verify that the power
On the unit is appropriate for your AC line voltage source.
Mounting Instructions:
The Flex Point Fiber Converter can be solo-mounted using a wall-mounting kit, or rack-
mounted using a 5-unit shelf, or a high-density Flex Point 14-unit Power-Redundant
Chassis.
