Black Box ME0010A-VDSL, Руководство пользователя

Страница: 8 / 21

9
3.0 INSTALLATION
Because the ME0011A-vDSL requires no configuration, it can be installed
quickly. If you are installing a standalone unit, refer to section 3.1 “Standal-
one unit installation”. Otherwise, refer to section 3.2 “Rack card installation”.
Note If asymmetric transmission or line rates other than 12.5 Mbps
are required, refer to section 4.0, “Configuration” on page 15.
3.1 STANDALONE UNIT INSTALLATION
Do the following:
1. Connect the line interface between the units (refer to section 3.3,
“Connecting the Twisted-Pair Line Interface” on page 11)
Note See Figure 2 for the standalone unit’s rear panel arrangements.
2. Connect the Ethernet interface (refer to section 3.4, “Connecting the
10/100Base-T Ethernet Interface” on page 12).
3. Connect the power plug (refer to section 3.6, “Connecting Power” on
page 14).
Figure 2. ME0011A-vDSL standalone rear panel
Ether
net
VLINK
Po
we
r
Made in the USA
POTS/ISDN
twisted-pair
terminal block
interface
Power
jack
Ether
net
VLINK
Po
we
r
Made in the USA
Ethernet
port
VDSL twisted-pair
terminal block
interface
VDSL twisted-pair
RJ-45 interface
PO
TS/ISDN
ME0010A-vDSL
ME0011A-vDSL