25
Figure 5-1. The Modem’s Help screen.
5.1.2 A
CCESS VIA
M
ODEM
To access the Secure Rack Modem’s Command mode via modem, dial the number
for the phone line connected to the modem. When the password prompt is
displayed, key in your system password (Default = SUPER) and press
[Enter]
. The
modem will display the Help screen as shown in Figure 5-1.
NOTE
The password is case-sensitive.
If the system dial back number has been defined (see
Sections 5.2
and
7.2.3
), the
modem will dial the defined number before allowing access to the Command
mode. In this case, when the valid system password is entered, the modem will
disconnect, and call the system dial back number before allowing access to
Command mode.
If the “Password on Dial Back” feature (see
Sections 5.2
and
7.2.4
) is enabled, the
modem will redisplay the password prompt to the answering party. If the
answering party enters the system password, the modem will allow access to the
Command mode.
Secure Rack Modem
Version 1.11
Site: (undefined)
COMMANDS
/H
Display Help Screen
/C View Audit Log
/G
View/Set General Parameters
/U Utilities
/M
View/Set Modem Parameters
/X Exit/Disconnect
/E
Edit Password Directory
/D
View Password Directory
Modem Type:
V2.200-V34_AGF_DP1
Reset String:
ATZ
Init String:
AT&C1&D2E0Q1V1M1S0=1&Q%C3
Hang-Up String:
(undefined)
MODEM PORT SETTINGS
Baud Rate:
9600
Result Codes:
Verbose
Flow Control:
RTS/CTS
Speaker:
On
Local Echo:
Off
Error Control:
On
Rings to Answer:
1
Compression:
On
Quiet Mode:
On
CHAPTER 5: Setup and Configuration
