Black Box FAS 200 / MFA, Руководство пользователя

Страница: 9 / 24

Installation
4
5 To adjust the angle of unit, loosen the screw of the tilt controller (12) and adjust
a tilt angle to the unit until hearing beep . The beep is occurred when the camera
is entering the proper angle range. If You decrease the angle again, You here
the same beep again. You should now carefully and slowly adjust the angle
within this range so, that You hear one long beep for 3 seconds continuously.
Fasten the screw in this setting. Wait for the announcement Camera setting is
completed . (or press the automobile type selection button once more) If you
should hear Camera setting error! you should repeat the adjustment
procedure beginning with Step 4 once more. It is important to proceed slowly
and carefully- only the long beep is the correct signal which is accepted by the
system.
Installation (Passenger Car, SUV, Larger SUV)
Press the car button , followed by the “Save” button of the remote
controller for selecting the vehicle type. You will hear “Systems will select
automobile types”. The 5 kinds of vehicle types are supported, passenger car,
SUV, larger SUV, bus/truck type 1 and bus/truck type 2. Please select a proper
vehicle type using volume buttons. Then the system gives a ring 2 times .
Now the the system will be ready for the camera angle adjustment.