Page 34
724-746-5500 | blackbox.com
Chapter 4: Control Operations
Update built-in EDID data by sending the UpgradeIntEDID[x]. command.
Examples:
1. Transfer signals from an input channel to all output channels: [x]All.
Example: Send “3All.” to transfer signals from input 3 to all output channels.
2. Transfer all input signals to the corresponding output channels respectively: All#.
Example: If this command is carried out, the status of the matrix will be: 1->1, 2->2,
3->3, 4->4…… 8->8.
3. Switch off all the output channels: All$.
Example: After running this command, there will be no signals on all the outputs.
4. Switch off the detailed feedback command from the COM port: /:MessageOff;
The switch will retain “switch OK” as feedback when you switch the matrix.
5. Switch on the detailed feedback command from the COM port: /:MessageOn;
It will show the detailed switch information when it switches. Example: when switch
1->2, the feedback will be “AV01 to 02”.
6. Transfer signals from an input channel to corresponding output channel: [x]#.
Example: “5#.” to transfer signals from the input5 to the output5.
7. Switch off an output channel: [x]$. Example: “5$.” to switch off the output 5.
8. Switch signal: [x1] B[x2]. Example: “1B2,3,5.” to transfer signal from the input1 to
the output No. 2,3,5.
9. Connect the input channel to the output channel [x]: Status[x]. Example: Send
“Status2.” to connect the input channel to the output 2.
10. Connect the input channel to the output channels one by one: Status.
Example: “Status” to connect the input channel to the output channels one by one.
11. Save the present operation to the preset command [Y]: Save[Y].
Example: “Save7.” to save the present operation to the preset command No.7.
12. Recall the preset command [Y]: Recall[Y]. Example: “Recall5.” to recall the preset
command No.5.
13. Clear the preset command [Y]: Clear[Y].
Example: “Clear5.” to clear the preset command No.5.