15
®
Resetting the configuration
The Wizard IP asks for an unknown admin password
This may occur if the Wizard IP has been previously configured. If the existing
admin password cannot be discovered, then your only recourse is to perform a
factory reset.
To invoke a configuration reset by switch
1 Remove power from the Wizard IP unit.
2 At the rear of the Wizard IP, adjacent to the power input socket, click mini
switch 1 to its ON (down) position.
3 Re-apply power to the Wizard IP. On the locally connected monitor you
should see a Maintenance menu:
Wizard IP Maintenance
Reset Configuration
return to normal operation.
Configure Network
Put option switch 1 up to
To upgrade unit, visit:
http://192.168.42.154
Wizard IP Reset Config
DO YOU WISH TO CONTINUE?
Cancel
RESET
WARNING: Continuing will cause
your existing configuration to
be erased.
The unit will then reset and
require re-configuring before
it can be used.
4 Select the ‘Reset configuration’ option.
A warning screen will be displayed. Select the RESET option and press
.
5 Remove power, return the mini switch 1 to its OFF position and then re-
apply power. The locally connected monitor should display the first screen of
the
initial configuration sequence
.
The Wizard IP does not display the configuration sequence
If the Wizard IP has been previously configured it may not automatically display
the first of the setup screens. In this case you have two options, either:
• Access the Unit, Network and Serial
configuration screens separately
, or
• Reset the configuration:
To invoke a configuration reset by main menu
1 Using the locally connected keyboard and screen, log on as the admin user.
2 Select the ‘Configuration’ option.
Wizard IP Configuration
Reset Configuration
Back
Modem Configuration
Network Configuration
Unit Configuration
3 Highlight the ‘Reset configuration’ option and press
.
A warning screen will be displayed, select the RESET option and press
.
Wizard IP Reset Config
DO YOU WISH TO CONTINUE?
Cancel
RESET
WARNING: Continuing will cause
your existing configuration to
be erased.
The unit will then reset and
require re-configuring before
it can be used.
4 The Wizard IP will reset and then display the first of the four
