8
SCSI Fiber Optic Extender
The SCSI Fiber Optic Extender requires no software configuration and
only nearby access to an AC electrical outlet for proper operation. That
makes installation fast and easy.
Install the Extender in any position and any location near the host
computer or peripherals that’s most convenient for you. Make sure that the
ventilation slots on the side of the unit are unobstructed and receive
adequate air flow.
Do not
place the Extender on any device that generates
heat.
N O T E
Switch off power to all computers and peripherals attached to the SCSI bus
before installing the SCSI Fiber Optic Extender.
3.1 Setting the AC Line Voltage Switch
The SCSI Fiber Optic Extender can be powered from either a 110- or
220-VAC power source. Figure 3-1 shows the location of the external
voltage-selection switch on back of the unit. The default setting is 110-VAC.
CAUTION
Before installing this unit, verify that the voltage-selection switch is
switched to the appropriate setting to match your AC input source.
Figure 3-1. Rear-Panel View.
POWER
O
I
AC INPUT
RCV
XMT
220
110
3. Installation
AC Voltage-Selection Switch
