CHAPTER 3: Hardware Installation
17
3. Hardware Installation
Your package should include the items listed in
Section 2.2
. You will also need an Ethernet cable, a serial cable,
and a VGA cable.
First, you will install the necessary cables and power supply. Then, refer to
Chapter 4
to install and configure
the Remote Video System IP’s software.
1. Connect the Ethernet cable to the 10/100 RJ-45 port on the Remote Video System IP’s back panel (see
Figure 2-2).
2. Connect the serial device’s cable to either the DB9 male Port 1 connector or the RJ-45 Port 2 connector.
3. Link the display device (monitor) cable to the VGA connector on the RVS’s back panel.
4. Connect the power supply to the back-panel power connector.
5. Plug the power supply into an AC power outlet.
NOTE
The 4-section speaker connector is not supported. It’s reserved for future use.
The next step is to install the software, as described in
Chapter 4
.
Figure 3-1. Hardware connections.
Connect
power supply
Connect
Ethernet
Connect
serial
device
Connect
display
device
4-section
speaker
connector
(not used)
Содержание AC1059A
Страница 3: ......
