4
5
SPECIFIC SAFETY INSTRUCTIONS FOR LITHIUM-ION BATTERIES
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, BURST HAZARD, OR INJURY TO
PERSONS OR PROPERTY:
Lithium-ion batteries are small, compact and ideal for providing long-lasting power to this unit. However, they
must be used and charged properly. Improper use can result in serious injury, fire, or death.
• Lithium-ion batteries can explode in the presence of a source of ignition. Do not use the product in the
presence of an open flame.
• Do not place this lithium-ion battery powered unit in fire or apply heat to it.
• Do not subject this lithium-ion battery powered unit to strong impacts or shocks. The battery in this unit
contains safety and protection devices which, if damaged, may cause the battery to generate heat, rupture or
ignite.
• Do not expose this lithium-ion battery powered unit to water or salt water, or allow the battery to get wet.
• Avoid storing this lithium-ion battery powered unit in the basement, bathroom or other areas of the house that
are or may become wet or humid or where moisture may concentrate.
• Do not leave this lithium-ion battery powered unit in direct sunlight, or use or store the unit inside cars in hot
weather. Doing so may cause the battery to generate heat, rupture, or ignite. Using the battery in this manner
may also result in a loss of performance and a shortened life expectancy.
• Never charge this unit near heat or flammable objects.
•
NEVER THROW WATER ON A BURNING LI-ION BATTERY! If a lithium-ion battery does catch on fire,
it will burn even more violently if it comes in contact with water or even moisture in the air. A fire
extinguisher must be used.
Battery Charging and Capacity
This unit is delivered in a partially charged state. You should charge it immediately upon purchase and must
charge it before using it for the first time.
When stored at room temperature with a full charge, Li-ion batteries will will begin to discharge from the time
they are manufactured, even when unused. Deep discharges also decrease their capacity. Battery life can be
extended by the following:
• Charge battery to full capacity before storage.
• Ideal storage temperatures for this unit range between 5°C and 20°C (41°F and 68°F).
• Never discharge the battery fully.
• Charge after each use.
• Always charge at least once every 3-6 months if not in frequent use to prevent overdischarge.
Transportation of Lithium-Ion Batteries
• Always check all applicable local, national, and international regulations before transporting a unit containing a
lithium-ion battery.
• Transporting an end-of-life, damaged, or recalled battery may, in certain cases, be specifically limited or prohibited.
SPECIFIC SAFETY INSTRUCTIONS FOR BATTERY BOOSTERS
WARNING: RISK OF EXPLOSIVE GASES
• Working in the vicinity of a lead acid battery is dangerous. Batteries generate explosive gases during normal
battery operation. For this reason, it is of the utmost importance that each time before using the jump-starter
you read this manual and follow instructions exactly.
• To reduce the risk of battery explosion, follow these instructions and those published by the battery
manufacturer and manufacturer of any equipment you intend to use in the vicinity of the battery. Review
cautionary markings on these products and on the engine.
CAUTION: TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE:
•
NEVER ATTEMPT TO BOOST OR CHARGE A FROZEN BATTERY.
• When working with lead acid batteries, always make sure immediate assistance is available in case of accident
or emergency.
• Never smoke or allow a spark or flame in vicinity of vehicle battery, engine or battery booster.
• Remove personal metal items such as rings, bracelets, necklaces and watches when working with a lead acid
battery. A lead acid battery can produce a short circuit current high enough to weld a ring, or similar metal
object, to skin, causing a severe burn.
• Do not operate unit with damaged cord or plug; or if the unit has received a sharp blow, been dropped, or
otherwise damaged in any way. Do not disassemble the unit; return it to the manufacturer when service or
repair is required. Opening the unit may result in a risk of electric shock or fire, and will void warranty.
• Do not leave the unit unattended while in use.
• This unit is not for use by children or infirm persons.
• Disconnect adapter by pulling the plug rather than the cord when disconnecting the 120V AC Charging
Adapter.
• Vehicles that have on-board computerized systems may be damaged if vehicle battery is boosted. Before
boosting, read the vehicle’s owner’s manual to confirm that external-starting assistance is suitable.
• Excessive engine cranking can damage a vehicle’s starter motor. If the engine fails to start after the
recommended number of attempts, discontinue boosting procedures and look for other problems that may
need to be corrected.
WARNING: TO REDUCE THE RISK OF SERIOUS INJURY OR PROPERTY DAMAGE:
•
This system is designed to be used only on vehicles with a 12 volt DC battery system. Do not
connect to a 6 volt or 24 volt battery system.
•
NEVER
connect this product to a positive grounded vehicle.
•
DO NOT use this battery booster on a watercraft.
It is not qualified for marine applications.
•
NEVER
charge/boost a battery that is removed from the vehicle.
• When charging using the 12V DC Boosting/Charging Cable:
– To reduce the risk of fire, make sure that the 12 volt outlet is free of debris and the Adaptor Plug fits tightly
in the outlet.
– Recharge using this method only when absolutely necessary. Never leave the unit unattended when charging
using this method.
PREPARING TO CHARGE/BOOST USING THE INCLUDED
BATTERY CLAMPS
1. Make sure all accessories in the vehicle are turned off, so as not to cause an electrical arc.
2. Clean the battery terminals, taking care to avoid getting corrosive material in your eyes.
3. Add distilled water in each cell until battery acid reaches level specified by battery manufacturer. This helps
purge excessive gas from cells. Do not overfill. For a battery without cell caps (maintenance free), carefully
follow manufacturer’s charging instructions.
4. Study all battery manufacturer’s specific precautions, such as removing or not removing cell caps while
charging, and recommended rates of charge.
Booster Location
• Locate the booster as far away from the battery as cables permit.
• Never place the booster directly above battery being charged; gases from battery will corrode and damage the
booster.
• Never allow battery acid to drip on the booster.
• Never operate the booster in a closed-in area or restrict ventilation in any way.
• Do not set a battery on top of the booster.
Battery Clamp Connection Precautions
• Connect and disconnect the battery clamps only after unplugging the 120V AC Charging Adapter from the
electric outlet.
• Make sure the engine is not running when connecting or disconnecting the battery clamps.
• Never allow clamps to touch each other.
• Attach clamps to battery and chassis as indicated in “Connecting the Booster Using the Included Battery
Clamps.”
P2G7B_ManualENSP_061715.indd 4-5
6/17/2015 10:03:22 AM