7
INSTALLING AND REMOVING THE
BATTERY PACK
WARNING:
MaKe suRe the
sWItch Is not actuated When
ReMovInG oR InstallInG BatteRy.
TO INSTALL BATTERY PACK:
Insert battery pack into trimmer until fully
seated and an audible click is heard
(figure B). Make sure battery pack is fully
seated and fully latched into position.
TO REMOVE BATTERY PACK: Depress
the battery release button in the back of
the battery pack and pull battery pack out
of trimmer (figure C).
B
C
SAVE THESE INSTRUCTIONS
ASSEMBLY AND ADjUSTMENT
WARNING:
BEFORE ASSEMBLY,
MAkE SURE THAT THE APPLIANCE IS
SWITCHED OFF AND THE BATTERY
HAS BEEN REMOVED.
ASSEMBLY TOOLS REQUIRED (NOT
SUPPLIED):
- Phillips Screwdriver
WARNING:
REMOVE THE BATTERY
BEFORE ATTEMPTING TO ATTACH ANY
OF THE FOLLOWING COMPONENTS.
ATTACHING THE GUARD (FIGURES D
AND E)
WARNING:
NEVER OPERATE
APPLIANCE WITHOUT GUARD FIRMLY IN
PLACE. The guard must always be properly
attached on the appliance to protect the user.
• Remove the screw from the guard.
• Keeping the guard square to the
trimmer head slide it fully into place
until the retaining tab clicks into place
(Ensure that the guide rails (D1) on the
guard (11) are correctly aligned with the
guide rails (D2) on the trimmer head
(D3) (figure D). The locking tab (D4)
should snapped into the housing slot (D5).
• Secure the guard with the screw (E1)
(figure E).
D
D2
D1
D3
D4
11
D5
E
E1
ATTACHING THE AUxILIARY HANDLE
(FIGURES F AND G)
• Push the auxiliary handle (F1) onto the
tube (F2).
• Slide the bolt (G1) through the holes in
the auxiliary handle.
• Tighten the knob (G2) onto the bolt by
turning it clockwise.
F
F1
F2
G
G2
G1