10
the open position. Ensure that the edging guide is all the way down,
an audible click will be heard.
Note: The head will only rotate in one direction.
Note: The Auto Feed System may not operate correctly if edge guide
is not used.
SWITCHING ON AND OFF
• To switch the tool on, press
in and hold the lock off button
(
L1
) then squeeze the trigger
lever (
L2
). Once the tool is
running you may release the
lock off button (
L1
).
• To switch the tool off, release
the trigger lever.
WARNING:
Never
attempt to lock the trigger
lever in the on position.
POWER COMMAND -
MAX POWER / MAX RUNTIME
The max power / max runtime
feature (
M1
) is located on the
tool handle. It allows you to
optimize the tools
performance and boost the
power as needed.
•
To choose max power to
tackle thick weeds, rotate dial
to setting 6.
•
To choose max runtime to
increase battery life rotate dial
to setting 1.
•
For a combination of both,
rotate dial to setting from 2 to 5.
OPERATING THE TRIMMER
• With the unit on, angle unit and slowly swing the
trimmer side to side as shown in
figure N
.
• Maintain a cutting angle of 5° to 10° as shown
in
figure N1
. Do not exceed 10°
(figure N2)
. Cut
with the tip of the line. To keep distance from hard
surfaces use edge guide (10). Pull the guide out
until it snaps securely into place
• Maintain a minimum distance of
24 inches
(609.6 mm)
between the guard and your feet as
shown in
figure N3
. To acheive this distance
adjust the overall height of the trimmer as shown
in
figure H
.
EDGING
Optimumcuttingresultsareachievedon
edgesdeeperthan2inches(50mm).
• Do not use the tool to create edges
or trenches.
• Guide the tool as shown in
figure O
.
• To make a closer cut, slightly tilt
the tool
.
L
L1
L2
M
M1
N
O
N3
5
O
-10
O
N1
N2
