English
5
Figure D
27
18
Removing a cleaning pad - Fig. D
CAUTION:
Always wear suitable shoes when
changing the cleaning pad on your steam mop. Do
not wear slippers or open-toed footwear.
1. Turn the steam mop ‘OFF’.
2. Wait until it cools down. (approximately five minutes)
3. Place the front of your shoe onto the cleaning pad
removal tab
27
and press down firmly.
4. Lift the steam mop up off the cleaning pad.
nOTE:
Do not store with a wet pad as this can damage
your floor. When stationary, make sure the steam mop is
turned off when not in use.
Hand-held steam cleaner attachments
nOTE:
Remove the hand-held steam cleaner from the
steam body after turning off and unplugging the steam
mop, and after allowing the steam mop to cool down.
Attaching the hose and steam glove -
Fig. E
1. Firmly press the hose
8
or
11
onto the steam nozzle
26
of the hand-held steam cleaner such that it is fully
seated.
2. To remove, depress the hose release button
28
, and
pull the hose out of the hand-held steam cleaner.
WARNING:
Inspect the seal
29
on the handheld
steam cleaner
2
and the seal
30
at the end of the
hose before each use (figure F). If the seal is missing or
damaged contact your nearest authorized repair agent.
Do not use the appliance.
CAUTION:
Ensure that the hose is securely fastened
before using the hand-held steam cleaner.
Figure E
30
28
8
29
ATTACHING OTHER ACCESSORIES TO
THE HOSE - Fig. F
For other accessories other than the steam jet nozzle,
align the lugs
31
on the hose
8
with the recesses on the
accessory.
1. Press the accessory onto the hose and twist clockwise until
the accessory is fully seated and clicks into place.
Figure F
31
8
Attaching steam jet nozzle - Fig. G
1. Press in the clips
32
on the steam jet nozzle
21
.
2. Align the two keys on the inside flange of the steam jet
nozzle with the two slots at the end of the hose
8
.
3. Firmly press the steam jet nozzle onto the hose such that
it is fully seated, and release the clips.
4. To remove, press the clips and pull the steam jet nozzle
away from the hose.
WARNING:
Inspect the seal
23
on the steam nozzle
of the hose
8
before each use (figure G). If the seal is
missing or damaged contact your nearest authorized
repair agent. Do not use the appliance.
CAUTION:
Ensure that the hose and/or steam jet nozzle
is securely fastened before using the hand-held steam
cleaner.
Figure G
32
8
REMOVING ACCESSORIES FROM THE HOSE
• For accessories other than the steam jet nozzle, turn
hand held steamer off, unplug, and allow to cool down.
Then twist accessory counterclockwise then pull away
from the hose.
FILLING THE WATER TANK
nOTE:
Fill the water tank with regular tap water.
nOTE:
In areas of very hard water, the use of de-ionized
water is recommended.
WARNING:
Do not over fill the tank.
1. Ensure that the appliance is switched off and the power
cord is disconnected from the power supply.
2. Open the filler cap
4
by pulling up (figure H).
3. Fill the water tank with water.
4. Close the filler cap.
nOTE:
Always empty the water tank after use.
nOTE:
Fill the water tank with clean tap water (Do not use
any additives or chemicals).
WARNING:
When filling, detach from main unit and
maintain in a horizontal position.
