Black & Decker HD18F2M, Руководство пользователя

Страница: 6 / 12

6
In case of eye contact, rinse copiously
with clean water for at least 10 minutes.
Seek medical attention.
Fire hazard! Avoid short-
circuiting the contacts of a
detached battery (e.g. keys
carried in the same pocket as a
battery).
Do not incinerate the battery.
Do not attempt to charge
damaged batteries.
Chargers
◆
Use your Black & Decker charger
only to charge batteries of the type
supplied with your tool.
Other batteries could burst, causing
personal injury and damage.
◆
Never attempt to charge non-
rechargeable batteries.
◆
Have defective cords replaced
immediately.
◆
Do not expose to water.
◆
Do not open the charger.
◆
Do not probe the charger.
The charger is intended for
indoor use only.
Electrical safety
Your charger has been designed for a
specific mains voltage. Always check
that the mains voltage corresponds to the
voltage on the rating plate.
Your charger is double
insulated in accordance with
EN 60335; therefore no earth
wire is required.
Never attempt to replace the
charger unit with a regular
mains plug.
Mains plug replacement
(U.K. & Ireland only)
◆
Should your mains plug need
replacing and you are competent to
do this, proceed as instructed below.
If you are in doubt, contact an
authorised repair agent or a qualified
electrician.
◆
Disconnect the plug from the supply
and remove the fuse from the plug.
◆
Cut off the plug and dispose of it
safely; a plug with bared copper
conductors is dangerous if engaged
in a live socket outlet.
◆
Only fit 13 Amperes BS1363A
approved plugs fitted with a 5 A fuse
(1).
◆
The cable wire colours, or a letter,
will be marked at the connection
points of most good quality plugs.
Attach the wires to their respective
points in the plug (see above).
Brown is for Live (L) (2), blue is for
Neutral (N) (4).
◆
Before replacing the top cover of the
mains plug ensure that the cable
restraint (3) is holding the outer
sheath of the cable firmly and that
the leads are correctly fixed at the
terminal screws.
◆
If the plug has a fuse cover, make
sure that the fuse cover is fitted.
Do not use the plug if the fuse cover
is missing or damaged.
Never use a light socket.
Features (fig. A)
1. On/off switch
2. Release button for dust bowl
3. Dust bowl