Black & Decker GL225, Руководство пользователя

Страница: 10 / 64

10
◆
Loop the cable through the cable restraint (9)
as shown to prevent the extension cable from
becoming detached during use.
◆
Insert the mains plug into a mains outlet.
The extension cable must be suitable for
outdoor use.
USE
Let the tool work at its own pace.
Do not overload.
Switching on and off (fig. A)
◆
To switch the tool on, push the on/off switch (1).
◆
To switch the tool off, release the the
on/off switch.
Never attempt to lock a switch in the on
position.
Hints for optimum use
◆
Hold the tool as shown in fig. G.
◆
Gently swing the trimmer from side to side as
shown in fig. G.
◆
When cutting long grass, work in stages from
the top.
◆
Keep the tool away from hard objects and
delicate plants.
◆
If the tool starts running slowly, reduce the load.
◆
In order to achieve optimum cutting results,
only cut dry grass.
◆
Replace the cutting line when worn.
MAINTENANCE
Your Black & Decker tool has been designed to
operate over a long period of time with a
minimum of maintenance. Continuous satisfactory
operation depends upon proper tool care and
regular cleaning.
◆
Before performing any maintenance,
switch off and unplug the tool.
◆
Do not use any abrasive or solvent-
based cleaner.
◆
Regularly clean the ventilation slots in your tool
using a soft brush or dry cloth.
◆
Regularly clean the cutting line and spool
using a soft brush or dry cloth.
◆
Regularly use a blunt scraper to remove grass
and dirt from the underneath of the guard.
◆
Regularly check the cutting line for wear.
Fitting a new spool of cutting line (fig. D)
Replacement spools of cutting line are available
from your Black & Decker dealer (cat. no. A6044).
◆
Remove the empty spool by pushing it down
(A) and turning counterclockwise (C).
◆
Assemble and fit the new spool as described
above.
Winding new line onto an empty spool (fig. D & F)
You may wind new cutting line onto an empty
spool. Replacement packs of cutting line are
available from your Black & Decker dealer
(cat. no. A6170 (25 m), A6171 (40 m)).
◆
Remove the empty spool from the tool as
described above.
◆
Remove any old cutting line from the spool.
◆
Locate one end of the cutting line in one of the
grooves (16) in the spool as shown.
◆
Wind the cutting line onto the spool in the
direction of the arrow. Make sure to wind the
line on neatly and in layers. Do not criss-cross.
◆
When the spool is full, clip it into the groove (12)
and cut the line. Let the line protrude at least
5 cm from the spool.
◆
Proceed as described above to fit the spool on
the tool.
Only use 1.5 mm diameter Black & Decker
cutting line.
TROUBLESHOOTING
If your tool seems not to operate properly, follow
the instructions below. If this does not solve the
problem, please contact your local Black & Decker
repair agent.
Before proceeding, unplug the tool.
E N G L I S H