Black & Decker Dustbuster WV6015, Оригинальное руководство пользователя

Страница: 6 / 84

6
ENGLISH

When disposing of batteries, follow
the instructions given in the section
"Protecting the environment".

Do not damage/deform the battery
pack either by puncture or impact, as
this may create a risk of injury and
fire.

Do not charge damaged batteries.

Under extreme conditions, battery
leakage may occur. When you notice
liquid on the batteries carefully wipe
the liquid off using a cloth. Avoid skin
contact.

In case of skin or eye contact, follow
the instructions below.
Warning! The battery fluid may cause
personal injury or damage to property. In
case of skin contact, immediately rinse
with water. If redness, pain or irritation
occurs seek medical attention. In case of
eye contact, rinse immediately with clean
water and seek medical attention.
Chargers
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate.
Warning! Never attempt to replace the
charger unit with a regular mains plug.

Use your Black & Decker charger
only to charge the battery in the
appliance/tool with which it was
supplied. Other batteries could burst,
causing personal injury and damage.

Never attempt to charge non-
rechargeable batteries.

If the supply cord is damaged, it must
be replaced by the manufacturer or
an authorised Black & Decker
Service Centre in order to avoid a
hazard.

Do not expose the charger to water.

Do not open the charger.

Do not probe the charger.

The appliance/tool/battery must be
placed in a well ventilated area when
charging.
Electrical safety
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate. Never attempt to
replace the charger unit with a regular
mains plug.
Symbols on the charger
Features
1. On/off switch
2. Release button
3. Dust bowl
4. Charging base
5. Charger
Fig. A
6. Crevice tool
7. Wet pick-up accessory
Installation
Fitting the charging base to the wall
(fig. B)
The charging base can be fitted to the
wall to provide a convenient storage and
charging point for the appliance.
Warning! Do not fit the charging base
directly over a mains supply. Ensure the
cord has a loop when the charger is
connected to the mains.
Read the manual carefully
before using the appliance.
Your charger is double
insulated; therefore no earth
wire is required.
Fail-safe isolating transformer.
The mains supply is
electrically separated from the
transformer output.
The charger automatically
shuts off if the ambient
temperature becomes too
high. As soon as the ambient
temperature has decreased,
the charger will resume
operating.
The charging base is intended
for indoor use only.
130
o
C