6
Grounded Indoor Digital Outlet Timer
OVERRIDE/RESUME PRESET PROGRAM
Press ON/OFF button each time to override/resume the preset program. LCD changes the
display in the following sequence:
1. ON: override the preset program and appliance remains on at all times
2. AUTO: resume the preset program, appliance will be turned on and off automatically
according to the preset time
3. OFF: override the preset program and appliance remains off at all times
CONNECTIONS
1. Preset your desired On/Off programs on the Timer as mentioned above.
2. Switch off your electrical appliance.
3. Connect your appliance’s power cord to the Timer’s socket, then connect the Timer to the
AC socket to get power.
4. Switch on your appliance.
5. Appliance will then be turned on/off according to your preset programs unless manual
override is pressed.
NOTICE:
This equipment has been tested and found to comply with the limits for
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on. The user
is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and the receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
Then, set the on/off time for the preset program.
Press HOUR to set number of hours
Press MINUTE to set minutes
To set other program group’s on/off time, re-
peat procedures mentioned from #2 to #7
(Refer to: DIAGRAM & DESCRIPTIONS
chart on page 4).
Noted: Image 1
(a) To change the power ON/OFF time of pre-
set program, repeat procedures #2 to #7 (Refer to: DIAGRAM & DESCRIPTIONS chart on
page 4) and input the new data to replace the old setting.
Or press RST/RCL once to cancel the power ON/OFF time setting, or press the same button
again to resume the previous setting.
-The set time can be canceled or resumed by pressing “RST/RCL” button, which is ef-
fective only in time setting
-When the set time is canceled, the given tacit time 12:00 AM (12 hours) or 00:00 (24
hours) can be displayed by pressing “Hour” , “Min” button.
-When the set time is canceled, it can be resumed by pressing “RST/RCL” button.
-When the power ON/OFF time is set, it becomes effective at once
(b) After program setting, press CLOCK button to return to clock display at once, or it will be
returned automatically after 15 seconds without pressing any other buttons.
Image 1
