26 • ENGLISH
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION
Motor hums and low noise
Spray gun not clean, or not lubricated
resulting in piston being stuck in cylinder
Disassemble spray gun and, clean with
thinner and add oil. Or replace the piston
pump assembly.
Motor hums but does not spray or
irregular spraying.
Worn swirl head
Replace swirl head.
Pick up pipe not in the right position
Re-adjust pick up pipe.
Blocked pick up pipe
Clean with thinner.
Blocked nozzle
Clean nozzle.
Blocked filter
Clean with thinner.
Control knob needs adjustment
Adjust.
Over painting.
Too much paint
Adjust the volume clockwise to reduce
spraying. Two thin coats are better then one.
Viscosity too low
Check viscosity
Atomization is not good.
Volume adjustment is not correct.
Adjust.
Paint too thick
Check viscosity of the paint.
No spray, no sound.
No electricity
Check power supply
Operating sound not right.
Poor output adjustment
Re-adjust
Not enough paint in the container
resulting in air being sucked in.
Refill with paint.
Not diluting properly or not passing
pick up pipe completely.
Check pick up pipe and viscosity level.
“Orange Skin” excessive fogging.
Incorrect solvent is used
Use correct solvent.
Spray gun too far from the surface.
Hold spray gun closer to the object
Paint too thick
Thin the paint
SERVICE INFORMATION
BLACK+DECKER offers a full network of company-owned and authorized service locations. All BLACK+DECKER
Service Centers are staffed with trained personnel to provide customers with efficient and reliable power tool service.
For more information about our authorized service centers and if you need technical advice, repair, or genuine factory
replacement parts, contact the BLACK+DECKER location nearest you, or visit us at www.BlackandDecker-la.com
Содержание BDPS130
Страница 2: ...FIG A FIG B FIG C FIG C FIG E 1 2 3 4 5 6 8 7 ...
Страница 3: ...FIG F FIG H FIG G M L K J I H ...
