33 - ENG
J. Pump Inlet
K. Quick Connect Nozzles
L. On Board Detergent Tank
(BDG3100-B3):
Feeds cleaning
agents into the pump to mix with
the water. See
How To Apply
Chemicals/Cleaning Solvents
instructions in
Operation
section.
BASIC ELEMENTS OF AN
ENGINE
Refer to the engine manual for location
and operation of engine controls.
Choke Control:
Opens and closes
carburetor choke valve.
Starter Grip:
Pulling starter grip
operates recoil starter to crank engine.
Engine Switch:
Enables and disables
ignition system.
ASSEMBLY INSTRUCTIONS
(FIG. 1– 4)
1. Locate and remove all loose parts
from the carton.
2. Cut four corners of the carton from
top to bottom and lay the panels flat.
3. Place handle (G) onto frame (H),
depress the snap buttons, and
slide the handle assembly onto the
frame until snap buttons snap into
place.
G
H
2
NOTICE:
Risk of personal injury. Avoid
placing hands between handle and
frame when assembling to prevent
pinching.
4. Remove the colored quick-connect
nozzles (K) from the plastic bag and
insert them into correct grommet on
the nozzle holder. Nozzles are color
coded to match colored nozzles on
label (Q).
K
Q
2A
5. Connect wand (E) to gun (D).
Tighten securely.
3
E
D
6. Attach high pressure hose (C) to
gun (D). Tighten se cure ly.
4
D
C
NOTE:
The pump on this unit is
maintenance free and requires no oil.
If there is a problem with the pump,
contact our Customer Service Group on
www.BlackandDecker-la.com
as
soon as possible.
NOTICE:
The engine is shipped without
oil. Before starting engine, add the oil
provided. Damage to the engine will
occur if the engine is run without oil,
this damage will not be covered under
warranty.
OPERATION
PRESSURE WASHER
TERMINOLOGY
PSI:
Pounds per Square Inch. The unit of
measure for water pressure. Also used
for air pressure, hydraulic pressure, etc.
Sometimes noted as “Bar”, another unit
of measure.
GPM:
Gallons per Minute. The unit of
measure for the flow rate of water.
CU:
Cleaning Units. GPM multiplied by
psi equals CU.
Bypass Mode:
Allows water to
re-circulate within the pump when the
gun trigger is not pulled. This feature
allows the operator to release the
