Black & Decker BDCR18, Оригинальное руководство пользователя

Страница: 6 / 84

6
ENGLISH (Original instructions)
Labels on tool
The following symbols are shown on the tool along with the
date code:
:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
Additional safety instructions for batteries and
chargers (where supplied)
Batteries
u
Never attempt to open for any reason.
u
Do not expose the battery to water.
u
Do not store in locations where the temperature may
exceed 40 °C.
u
Charge only at ambient temperatures between 10 °C and
40 °C.
u
Charge only using the charger provided with the tool.
u
When disposing of batteries, follow the instructions given
in the section "Protecting the environment".
p
Do not attempt to charge damaged batteries.
Chargers
u
Use your BLACK+DECKER charger only to charge the
battery in the tool with which it was supplied. Other batter-
ies could burst, causing personal injury and damage.
u
Never attempt to charge non-rechargeable batteries.
u
Have defective cords replaced immediately.
u
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
$
The charger is intended for indoor use only.
+
Read the instruction manual before use.
Electrical safety
#
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on
the rating plate. Never attempt to replace the
charger unit with a regular mains plug.
u
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. On/Off switch
2. Lock-off button
3. Shoe
4. Blade clamp release lever
5. Blade
6. Battery (where supplied)
7. Battery release button
8. Main handle
9. Secondary gripping handle
Figure D (where supplied)
10. Charger
Assembly
Warning! Before assembly, remove the battery from the tool
and make sure that the saw blade has stopped. Used saw
blades may be hot.
Fitting the saw blade (fig. A)
u
Hold the tool away from the body.
u
Open the blade clamp release lever (4) to the full open
position.
u
Insert blade shank from the front.
u
Close blade clamp release lever (4). Check to make sure
the blade (5) is clamped securley.
Note: The blade can be installed with the teeth up to assist in
flush cutting (fig. G).
Removing the saw blade
Warning! Do not touch the blade immediately after use. Used
saw blades may be hot.
u
Open the blade clamp release lever (4) to the full open
position.
u
Remove the blade.
Lock-off button
The tool is equipped with a switch lock-off feature to prevent
unintentional operation.
u
To switch the tool on, press the lock-off button (2) then
squeeze the on/off switch (1).
u
Releasing the on/off switch (1) turns the tool off.
Fitting and removing the battery (fig. B & C)
u
To fit the battery (6), line it up with the receptacle on the
tool. Slide the battery into the receptacle and push until
the battery snaps into place (fig. B).
u
To remove the battery (6), push the battery release button
(7) while at the same time pulling the battery out of the
receptacle on the tool (fig. C).
Use
Warning! Let the tool work at its own pace. Do not overload.