14
Check the drive belt carefully for wear, cuts and stressed areas. If the drive belt
appears worn, you will need to replace it.
To remove the drive belt, read the instructions and follow the drawings below:
1. Grasp the old drive belt and remove from motor shaft. Discard old drive belt.
2. Loop new drive belt over motor shaft and stretch other end over floor brush
in the space provided between the bristles.
4. Place ends of floor brush down into slots on sides as shown.
5. Turn floor brush by hand several times in the direction of the motor shaft.
If properly installed, drive belt will align itself on floor brush.
6. Replace brush cover and six screws.
Maintenance And Care - Replace Drive Belt
WARNING:
Turn off and unplug vacuum cleaner before performing
maintenance to the vacuum cleaner.
1
2
4
3
Replace Brush
Cover and
S
i
x
Screws
