19
saved settings from that location. If the selected memory location does not have any
saved settings, the message
Recall Data Empty!
will be displayed.
Note: When in Recall mode, users can recall settings from different locations without
having to press additional keys each time. For example, you can press 1 to recall
settings in location 1, and then press 5 to immediately recall settings in location 5.
3.
To exit
Recall
mode at any time, press the
button again or press
.
3.7
Key Lock
The front panel keys can be locked to prevent unwanted changes to output settings and power
supply configurations. Follow the steps below to enable/disable key lock.
1.
Press the
key and the
button. A
Lock
indicator will light up on the
display, indicating that the front panel keys are locked. At this point, all keys are disabled
except for the
key,
button and
button.
2.
To unlock the keys, press the
key and
button again. The
Lock
indicator
will disappear and all keys will be enabled.
3.8
Output Check
Voltage Check
Follow the steps below to check the voltage output with no load connected.
1.
Turn on the power supply. The display should look like the following.
Figure 10 - Voltage Check
2.
Enable the output by pressing
; the button will illuminate. The <
>will be
replaced with a numeric value and a
next to this value for each channel.
3.
Press the
button if it is illuminated to enter the settings mode.
4.
Press
first, and then a numeric value on the keypad and then press the
button.
Note: The
button will automatically return to meter mode and illuminate
after 5 seconds of a valid entry (see 4.10 Return Meter to disable this).
