24
4.8
Memory Group
Up to 36 instrument settings can be stored into the instrument’s non-volatile memory. The
internal memory bank is divided into four groups. They are Grp1, Grp2, Grp3 and Grp4. Each
group can save 9 different operating states (1-9).
From the Config menu, select
MemoryGroup
and press the
button.
Use the
keys or rotary knob to select one of the four groups – Grp1, Grp2, Grp3, or
Grp4 and press the
button.
To save the first 9 instrument settings, select
Grp 1
, then exit the menu and follow the
instructions in section “3.6 Save/Recall Instrument Settings” to save and recall settings. To save
additional settings, select
Grp 2, Grp3, or Grp4
, then follow the same steps in section 3.6.
4.9
Protocol
From the
Config
menu, select
Protocol
and press the
button.
There are three options:
DEFAULT, EXT1, LEGACY
. Select one of the options by using the
keys or rotary knob and press the
button. The
DEFAULT
option is
recommended for most applications. The
LEGACY
option supports compatibility with B&K
Precision 9130.
Note: EXT1 is not used.
4.10
Return Meter
This option allows users to enable an internal fixed timer delay (5 seconds) for the power
supply to automatically switch from settings mode to meter mode. When enabled, it will
automatically switch to meter mode after 5 seconds. The backlight of the
button will
illuminate. In this state, pushing the button again to toggle back to settings mode will reset the
5-second timer again before the supply changes back to meter mode.
From the
Config
menu, select
ReturnMeter
and press the
button.
1.
There are two options that can be selected by using the
keys or rotary knob.
Select
OFF
or
Wait5Sec
and press the
button
.
