BIXOLON SRP-E770III Series, Руководство по обслуживанию, Страница: 12 / 63

SRP-E770III
2-2-6 Factory Reset
This function is used to reset the printer settings to factory default setting.
How to reset the printer
1) Depress the feed button for two seconds during print standby mode.
2) LED will change to orange color and release the feed button.
The printer will be set to stand-alone configuration mode.
3) Depress the feed button at the LED sequence in 2-2-4(Orange LED or Red LED 3times blink) to reset
the printer to factory default settings, and media calibration function will be executed.
- Orange LED 3times blink: Factory Reset and Gap calibration
- RED LED 3times blink: Factory Reset and Black-mark calibration
2-2-7 Media Length Measurement
The printer needs to have the exact length of currently installed paper to make a proper print image.
For this, the printer automatically starts Media Length Measurement Mode in the following conditions.
1) When the printer has no measure length, for example first feeding after installation.
2) When the detected label length differs from the measured value.
In this mode, the printer feeds 2 or 3 labels to measure the exact length of label and saves the measured
value on printer’s non-volatile memory.
2-2-8 Media Sensor Auto-Calibration
Media sensor auto-calibration is used when the printer does not detect a gap or black mark on the label
paper correctly.
Generally a printer is set to detect most types of gap or black mark but sometimes it fails to detect and keep
feeding the paper without a stop when special paper used. In such case, use media sensor auto-calibration
function for a proper detection.
1) Make sure that paper roll has been installed properly.
2) Use Stand-alone Configuration Mode, Sequence Number 2 or 3(refer to 5-1)
- Sequence Number 2: Gap Media Auto-Calibration
- Sequence Number 3: Black Mark Media Auto-Calibration.
Ver. 1.01
- 12 -