BIXOLON SLP-TX400, Руководство по обслуживанию

Страница: 13 / 81

Rev. 1.04 - 13 -
SLP-TX400x/TX403x
5) Narrow Ribbon Installation
When using ribbons of widths of 110mm or lower, install in a centered position on the holder.
6) Ribbon Removal
(1) Use a knife or other sharp-edged object to cut the ribbon.(Take care not to injure hands)
(2) Open the ribbon assembly and remove the ribbon and core by pushing from left to right.
(3) Detach the ribbon holder from the ribbon and core.
7) Ribbon Sensor Activation
To activate the ribbon sensor, check to see if the dip switch is properly set. (Refer to dip switch table)
If the ribbon sensor is inactive, detection of low ribbon levels and/or disconnected ribbons is not possible.
※
CAUTION
- When replacing a ribbon, keep affixed the core of the fully used ribbon to the ribbon coiling portion on the
other side and do not discard as its use is required.
- As the ribbon holder is required for continuous use, make sure not to misplace it.
Cutting