_______________________________________________________________________
_BITTEL
Page 9 of 13 HWDCD9888(38)TSD
Please view following different flash time:
Digit Key
FLASH TIME
Digit Key
FLASH TIME
1
100ms
7
700ms
2
200ms
8
800ms
3
300ms
9
900ms
4
400ms
0
1000ms
5
500ms
*
1100ms
6
600ms
#
1200ms
e. Setting local area code,
LCD display “ AREA CODE”, enter the code directly , press [SET] key and LCD
display “OK” , press [SET] key again to confirm.
f. Adjust LCD contrast :
LCD display “LEVEL 2” , press [UP]or[DOWN] key to adjust , total 6 levels.
Factory default : 3 level.
g. Setting PBX code
Press UP/DOWN key to find the “ PBX CODE” , press digits (0—9) , press [SET] key
and LCD display “OK” , then press [SET] key again to confirm.
TO REGISTER THE HANDSET
If the battery installed and the base charge with UPS , the handset can not work means
the handset not register to the base, please do as following:
1.
Under the base in on-hook mode, press MUTE key for a while and LCD display
“PLEASE WAIT” with the SYSTEM indicator light flashing , then release the
MUTE key.
2.
Within 10 seconds press the MUTE key on handset and waiting the “dididi…”sound
then release MUTE key.
3.
After finish the up two steps, the base escape “PLEASE WAIT” mode and handset
send out “dididi…” sound , now the registration succeed.
4.
If the handset can’t registered and there are some indicator sound during registration
that means this base is full of handset (6 handsets at most) .Under such condition,
delete one or several registered handset and register the new handset set again. Detail
as below :
The base in On –hook mode , press[SET] key first, then press UP/DOWN key to
find DEREGISTER, and press [SET] key again , LCD display “ ERASE” , then
