8
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
Filter Maintenance or Replacement
Inlet Filter
1.
Unplug the vacuum from electrical outlet.
2.
Open the dust bag compartment by lifting up
on the latch on the door at the front of the
canister. Lift out the bag holder and bag.
3.
Remove filter and clean by washing in warm
water with a mild detergent if desired. Allow
filter to dry completely before reinstalling. If
filter is torn, replace with a new filter.
NOTE: The filter should be placed so the
thicker grey foam side is visible.
4.
Place bag holder and bag back into bag
compartment making sure entire bag is
below seal gasket.
5.
Close dust bag compartment door and press
down gently until it locks into place.
Final Filter
1.
Unplug the vacuum from electrical outlet.
2.
Remove filter door and filter by pressing
down on tab at the back of the canister.
3.
Remove filter and clean by washing in warm
water with a mild detergent if desired. Allow
filter to dry completely before reinstalling. If
filter is torn, replace with a new filter.
NOTE: The filter should be placed so the
thicker grey foam side is visible.
4.
Reinstall filter and door by aligning notches
at the bottom and pressing tab back into the
canister.
M
aintenance and care
Inlet Filter
Final Filter
ug110-4001_7100_507.indd 8
ug110-4001_7100_507.indd 8
5/22/07 5:01:19 PM
5/22/07 5:01:19 PM
