www.BISSELLdirect.co.uk
8
Operations
Carpet Washing
1.
Plug the machine into a proper outlet. Turn the
power ON by pressing the red power switch on
the back of the machine with your foot.
2.
With your foot, press the gray handle
release lever located on the back of machine
below water tank.
3.
While pressing the spray trigger, make one
slow forward wet pass and another back. Let
the BISSELL® formula and DirtLifter PowerBrush
do the work for you.
Caution: Do not overwet.
4.
Release the spray trigger and make one
slow forward and backward pass over the
same area to remove any residual dirty water
and aid in drying.
5.
Repeat cleaning passes until solution being
pulled up appears clean. Continue passes
without pressing the spray trigger until you
can’t see any more water being suctioned up.
Empty the 2-in-1 Water Tank/
Clean Removable Nozzle
1.
Turn power switch OFF. Remove the 2-in-1
Water Tank from the base using the tank carry
handle. Carry the tank like a bucket to a utility
sink or outside where you will dispose of the
collection water. Remove the top of the tank by
rotating the handle forward to unlatch lid and
lifting lid off tank.
2.
Empty collection water from bottom of tank.
3.
After each use, remove and rinse the lint
screen located on the tank lid.
4.
If nozzle needs to be cleaned, remove by
grasping handle at the top and pulling forward.
Clean Removable Nozzle by rinsing under
running water.
5.
When finished, replace nozzle by slightly
raising front of machine to line up slots on the
base with the hooks on nozzle. Attach at base
first and then click nozzle into place.
NOTE: If nozzle is not attached properly loss
of suction will occur.
6.
To continue carpet washing, refer back to
“Fill the 2-in-1 Water Tank” instructions on page
7 and “Carpet Washing” instructions above.
If cleaning is complete, refer to the
“Maintenance and Care” section on page 10.
Handle Release
2.
3.
1.
5.
Lint Screen
Power Switch
4.
CAUTION
ROTATING BRUSH INSIDE-TO AVOID THE RISK
OF INJURY-UNPLUG BEFORE REMOVING
