6
BISSELL.com
Sanitizing with Spot Mode
Spot mode can be used with BISSELL Hard Floor Sanitize Formula to sanitize floors after tough messes,
like a pet accident. Spot mode also works to give certain areas extra cleaning attention when used with
BISSELL Multi-Surface or Hard Floor Formulas. Access Spot mode in the BISSELL Connect App.
Note:
You can sanitize 3 or 4 different areas around your home with a single tank.
HARD FLOOR
SANITIZE
Water
Formula
1.
Add BISSELL Hard Floor
Sanitize formula following the
steps on page 5.
2.
Wipe up the mess with
disposable towel.
3.
Place the robot in the center
of the area you want to clean
and select “Spot” mode in the
BISSELL Connect App.
Water
Formula
40 inches
(1m)
40 inches
(1m)
40 inches
(1m)
40 inches
(1m)
Water
Formula
4.
The robot will clean in a
spiral pattern, covering an area
approximately 40” x 40” or
1m x 1m for approximately 5
minutes. The robot will beep to
let you know it’s finished.
5.
Use caution when removing
robot as the floor may be
slippery. Allow to remain wet
for 5 minutes.
Manual Cleaning
x2
1.
Turn the robot ON. Press
the Start/Pause Button to start
cleaning.
2.
The robot will clean hard
surfaces and avoid most soft
surfaces, such as area rugs and
carpet.
3.
Return the robot to the dock.
Press the Start/Pause Button
twice. The light ring will flash
white as it finds its way back.
Note:
The robot will stop if water is low. To resume cleaning, refill Mop Tank and push the
Start/Pause Button.
Mop Mode
(continued)