w w w . b i s s e l l . c o m
M
aintenance and care
8
dust bag replacement
1.
Unplug the vacuum from electrical outlet.
2.
Open the dust bag compartment by lifting
up on the latch on the door on the front of
the vacuum, until the door locks into place.
3.
Close the filter bag by pulling the card-
board strap. This serves to cleanly seal the
full dust bag. Lift out the dust bag holder
and dust bag by pulling vertically on the
convenient handle, located on top of the
dust bag holder.
4.
Release the dust bag from the holder by
grasping the cardboard strap, which was
used to seal the full dust bag, and pulling
to the right, removing the dust bag out of
the holder. Discard the used dust bag.
5.
Slide the new dust bag into the holder by
inserting the dust bag into the tabs located
at the bottom of the holder. make sure the
dust bag has slid completely into place for
proper use.
6.
Place holder and new dust bag back into
the dust bag compartment, making sure the
entire bag is tucked in below the seal gasket.
7.
Close dust bag compartment door and
press down gently until it locks into place.
note: the dust bag compartment
door will not close without the dust
bag in place.
the HePa media pre-motor filter
protects the motor from dirt and
dust particles and assists in the fil-
tration process to return clean air to
the room.
1.
Unplug the vacuum from electrical outlet.
2.
Open the dust bag compartment by lifting
up on the latch on the door at the front of
the vacuum until the door locks into place.
Lift out the dust bag holder and dust bag.
3.
Remove the filter frame from the filter
holder by grasping the lip of the frame
and pulling up.
Replacing the HePa media pre-motor filter
notice:
This product is intended for house-
hold use only and not for commer-
cial or industrial use. Vacuuming
of dust from products like plaster,
concrete or ashes will damage the
motor and void the warranty.
HEPA media Pre-Motor Filter
3.
2.
3.
WaRning:
To reduce the risk of electric shock,
turn power switch OFF and
disconnect plug from electrical
outlet before performing mainte-
nance or troubleshooting checks.
