M
aintenance and care
The Pre-motor Filter prevents dust
and debris from interfering with
the operation of your vacuum. It
should be regularly checked for
wear or damage and replaced
when torn.
1.
Turn the power OFF ( ). Unplug the
vacuum from electrical outlet.
2.
Disconnect hose.
3.
Open the dust bag compartment by lifting
up on the door latch at the front of the
vacuum. Follow the instructions on page
9 to remove and dispose of the dust bag.
4.
Remove the filter frame from the filter hold-
er by gently pressing down on the top tab
and pulling the filter frame up and away
from the filter holder.
5.
Remove the filter from the filter frame and
clean by hand washing in warm water.
A mild detergent can be used if desired.
Allow the filter to air dry completely
before replacing.
6.
Place the filter back into the filter frame
and replace back into the filter holder,
snapping it back into place.
NOTE: The filter frame should be
placed so that the protective frame
is visible.
7.
Following the steps on page 9, replace
the dust bag, making sure the entire back
is tucked in below the seal gasket.
8.
Close dust bag compartment door and
press down gently until it locks into place.
9.
Reconnect the hose.
NOTICE:
This product is intended for household
use only and not for commercial or
industrial use. Vacuuming of dust
from products like plaster, concrete or
ashes will damage the motor and void
the warranty.
Tip:
For maximum cleaning
performance, check the filters often
and clean or replace if necessary.
WARNING:
Do not operate cleaner with
damp or wet filters or
without all filters in place.
Cleaning the Pre-Motor Filter
Pre-Motor
Filter
4.
w w w. b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
10
