Pre-treating
To aid in the removal of tough, stubborn stains,
pre-treating the stain may be necessary.
1.
Hold the unit above the area to be cleaned.
Using the manual trigger spray, apply a sufficient
amount of water and solution to the stain.
2.
Wait 3-5 minutes before cleaning.
Cleaning
1.
Turn the power switch to the “ON” position. (
I
)
2.
While holding the Spot Lifter above the area
to be cleaned, apply water and formula by
pressing the manual trigger spray, dispensing
fluid to the soiled/stained area.
3.
Brushing and suction can be done separately,
based on how you hold and use the unit.
For Suction Only:
Tilt the unit forward, pressing the front of the
Spot Lifter firmly against the surface area to be
cleaned, lifting the brushes up off the surface.
Pull toward you to remove the soil and cleaning
solution.
NOTE: Step 3 may be repeated until no more
dirty water is removed or until the area to be
cleaned meets your satisfaction.
4.
Check the collection tank and empty the tank
if it is full (to empty the collection tank, see page
8).
5.
If the Spot Lifter stops spraying, turn off the
unit and check the cleaning solution level in the
solution tank. Refill if needed. Never run the unit
without water or cleaning solution.
Spot cleaning upholstery
1.
Check manufacturer’s tag before cleaning.
“W” or “WS” on the tag means you can use your
Spot Lifter PowerBrush. If tag is coded with an
“S” (with diagonal strike-through) or states “Dry
Clean Only”, do not proceed.
2.
If manufacturer’s tag is missing or not coded,
check with your furniture dealer.
3.
If possible, check upholstery stuffing. Colored
stuffing may bleed through fabric when wet.
Operations
www.BISSELL.ca
1-800-263-2535
WARNING
Keep spray away from face. Failure to do
so may result in personal injury.
IMPORTANT
Check the manufacturer’s tag before
cleaning upholstery. “W” or “WS” on the tag
means you can use your SpotLifter. If tag
is coded with an “S” (with diagonal strike-
through), or says “Dry Clean Only,” do not
proceed. If manufacturer’s tag is missing or
not coded, check with your furniture dealer.
7
