Machine care
1.
Turn the power switch to the “OFF” position. (
O
)
2.
Carry the Spot Lifter to the sink or drain.
To empty the collection tank
1.
Remove the collection tank by pressing the
tank release button at the top of the tank. The
tank will pivot out on a “hinge” at the bottom of
the unit.
2.
Remove the tank plug by turning
approximately 1/4 turn counterclockwise and
lifting out. Empty tank.
3.
Thoroughly rinse the collection tank with clean
water. Be sure to rinse nozzle area.
4.
Replace tank plug and turn approximately 1/4
turn clockwise, until snug.
5.
To replace the tank, pivot bottom of tank back
into “hinge” and tilt up to handle. Press the tank
release button, and snap the tank into place. Test
for a secure fit before using.
Note: If a significant amount of water and
formula remains in the solution tank, you
may leave it in the solution tank for your next
cleaning task.
Machine storage
1.
Clean exterior surface of Spot Lifter with a soft
cloth dampened with water only. Do not use a
strong detergent or other cleaners as this may
damage the finish.
2.
Store Spot Lifter in a protected dry area, at
room temperature (40° - 110°F).
Battery removal and disposal
1.
Important: Unplug charger.
2.
Remove tanks (front and rear) and discard.
3.
Remove screws (6) holding product housing
together.
4.
Use screwdriver to score rating label on bottom of
unit.
5.
Separate housings and locate battery pack in
bottom/center of unit.
6.
Remove wire connectors from the battery pack.
7.
Keep battery pack together - DO NOT separate
individual batteries. For specific disposal instructions
of batteries, please contact: RBRC (Rechargeable
Battery Recycling Corporation) 1-800-723-1297 or
visit www.rbrc.ca .
8.
Discard remainder of product.
www.BISSELL.ca
1-800-263-2535
8
Maintenance & Care
WARNING
This product contains a
rechargeable nickel cadmium
battery (sometimes referred
to as a “Ni-Cad” battery) pack.
The average life of a Ni-Cad
battery is 5-7 years, depending
on frequency of use. According
to Federal regulations, proper
removal and disposal of Ni-Cad
batteries is required.
1.8
00.723.12
97
3.
Screws
