Place one end of the new Drive Belt over Motor Pulley and the
other end over the Brush in the space between the bristles.
Pull the Brush firmly to stretch the Drive Belt and place ends
of Brush down into slots on sides as shown. Turn Brush
several times by hand to center the Drive Belt.
Reposition Brush Cover and screws. Tighten
screws securely.
Select Models Only
The TurboBrush should be checked regularly for clogs
or debris wrapping around the Brush Roll.
Unplug vacuum from electrical outlet.
If a clog is present or debris is visible, unscrew the two
screws on the back of the TurboBrush to remove the
faceplate and clear any obstructions.
To clean debris from the Brush Roll, remove the screw
located on the Belt Cover. Lift the Belt Cover. Remove the
Brush Roll from the Drive Belt and clean debris.
Reposition the drive belt on the Brush Roll. Place ends
of Brush Roll in slots on sides as shown. Reposition Belt
Cover and secure with shorter screw. Reposition faceplate
and secure with two longer screws.
12
1.
2.
3.
4.
TurboBrush Maintenance
Belt Cover
Rotating Brush and Drive Belt Maintenance Continued
9.
10.
11.
WARNING:
To reduce the risk of electric
shock, turn Power Switch
OFF and disconnect plug
from electrical outlet before
performing maintenance or
troubleshooting checks.
ug603-5570_3760E_1105.indd 12
ug603-5570_3760E_1105.indd 12
2/2/06 4:12:19 PM
2/2/06 4:12:19 PM
