w w w. b i s s e l l . c o m
M
aintenance and care
8
brush roll reset:
if larger debris becomes lodged in the
foot of the unit and the brush roll shuts
off, turn the unit off and remove the
obstruction. Wait approximately 15 sec-
onds for the motor to cool down before
turning back on. brush will function
again after allowing time to cool down.
brush roll belt replacement:
if the brush roll belt should break,
please call local bissell consumer
services to purchase replacement belt.
Replacement instructions:
1.
Turn power oFF (o). remove foot
assembly from unit and turn over to
access the brush roll belt.
2.
remove three Phillips head screws to
remove the belt cover.
3.
Locate broken belt.
4.
replace belt by sliding the belt over the
motor pully and then sliding brush in.
Alighn the belt on the groove of the brush
roll.
5.
Place brush roll back into foot of unit.
6.
replace the belt cover and secure with
three screws.
7.
rotate brush manually to properly
seat belt.
8.
Attach foot assembly on unit.
disposal of batteries
if your lift-off floors & more is to be
disposed of, the batteries should be
removed and disposed of properly.
1.
imPoRtant:
Unplug charger.
remove from charging base and fully
|discharge hand vacuum.
2.
remove dirt container from handle.
3.
remove (5) Phillips head screws on
the handle and cover.
brush roll and brush roll belt maintenance continued
2.
4 & 5.
WaRning:
This product contains a
rechargeable nickel metal
hydride battery (sometimes
referred to as a “NiMH”
battery) pack. The average life of
a NiMH battery is 5 to 7 years,
depending on frequency of use.
Proper removal and disposal of
NiMH batteries is required.
3.
5 screws