w w w . b i s s e l l c o m m e r c i a l . c o m 8 5 5 . 5 4 4 . 7 3 3 6
M
aintenance and care
8
Red Sensor Light
The red sensor light on the foot of the
vacuum will turn red if:
a.
dust bag is full
b.
there is a blockage in the hose or
power head
c.
brush roll is working improperly
*if you ignore the red light eventually the machine
will shut off. if the red light changes to green
the vacuum is working properly
While you are vacuuming you should
see a green light on the foot of the
vacuum. If this changes to red it is time
to change the paper filter.
1.
Remove the yellow bar (filter sensor)
located vertically across the filter
2.
Place new filter in by sliding it in where
the old one was located.
3.
secure the filter by reattaching the yellow
bar (filter sensor)
To Change the Brush Roll
1.
unplug the vacuum from the
electrical outlet
2.
turn the vacuum over so you have access
to the bottom of the vacuum foot
3.
loosen the two large screws until
they click
4.
starting on the right as you face the
vacuum click the tabs open in a counter-
clockwise motion
5.
Pull plate off of bottom of foot
6.
grab brush and pull
7.
Replace with new brush
8.
Reverse steps 4 and 5 and tighten
the screws
Replacing Paper Filter (located behind bag)
