The Filter Cup may be washed in warm water with a
mild detergent. Make sure it is completely dry before
reassembling with filters.
The Upper Tank and Louvers may also be wiped clean
with a damp cloth. Reach underneath the Upper Tank
and turn the rim of the Louvers to unlock. Pull straight
down to remove.
Unplug the cleaner from electrical outlet.
The Pre-Motor Filter protects the motor from debris. It is
located underneath the Dirt Container and Filter Cup in
the center of the round part of the Lock ‘n Seal Lever.
Remove the small round Filter and any debris on top of
it. Rinse well under warm water, then air dry thoroughly
before replacing.
Use only BISSELL Style 12 HEPA Filters (#3205) in
your BISSELL PowerForce Turbo Bagless.
Unplug the cleaner from electrical outlet.
The HEPA Post-Motor Filter assists in the filtration process
to return clean air to the room. It is located behind the door
on the front of the cleaner. When the filter becomes dirty,
open the door, remove the filter and replace.
Note: This filter is not washable and must
be replaced.
Replace the door by inserting the tabs on the left side
and snapping the right side into place.
The TurboBrush should be checked regularly for
clogs or debris wrapping around the brush roll.
Unplug vacuum from electrical outlet.
If a clog is present or debris is visible, unscrew the two
screws on the back of the TurboBrush to remove the
faceplate and clear any obstructions.
To clean debris from the brush roll, remove the screw
located by the brush roll with a Phillips head screw-
driver. Lift the belt cover. Remove the brush roll from
the drive belt and clean debris.
Reposition the drive belt on the brush roll. Place ends
of brush roll in slots on sides as shown. Reposition belt
cover and secure with one screw. Reposition faceplate
and secure with two screws.
Cleaning The Inner & Outer Circular Filters continued
9
Replacing the HEPA Post-Motor Filter
1.
2.
WARNING:
Do not operate cleaner
with damp or wet
filters or without all
filters in place.
WARNING:
To reduce the risk of
injury from moving parts,
turn off vacuum cleaner
and disconnect Power
Plug from electrical outlet.
5.
6.
3.
Cleaning Pre-Motor Filter
1.
2.
3.
HEPA
Post-Motor
Filter
Pre-Motor
Filter
Maintaining TurboBrush
1.
2.
3.
4.
ug203-2829_6596_1105.indd 9
ug203-2829_6596_1105.indd 9
1/11/06 4:03:38 PM
1/11/06 4:03:38 PM
