Bison 375911150100, Инструкция по эксплуатации

Страница: 44 / 88

22
6.7. Lubrication and maintenance guide

It is recommended to lubricate spacer every 40 hours of work. Use lubricant fitting 35
(Fig. 14) located on the top of base.

Depending on needs, but not rarely then every 2 000 hours of work, dismantle super
spacer and clean all surfaces.

Lubricate the working surfaces of sleeve 2 (Fig. 14; Fig. 15).

Inspection and maintenance of lathe chuck 46 (Fig. 14; Fig. 15) should be performed
according to chuck instruction manual.
7.
WORK SAFETY REGULATIONS

Operator must read this instruction before attempting to operation.

In case of abnormal work of spacer or damages, stop the work and inform
supervision staff.

Qualified personnel must perform repairs and overhauls.

Except mentioned above regulations observe your local safety rules.
8.
FINAL REMARKS

Following the instructions given in this manual provides long lasting and
trouble-free vice operation.

Failing to do this will void any manufacturer warranties and liability.

While mounting lathe chuck 46 (Fig. 14; Fig. 15), make sure that “0” mark at
pinion of chuck is opposite “0” mark on sleeve 2 (Fig. 14; Fig. 15).
Manufacturer reserves the right to make the construction changes without notice.
General Terms and Conditions of a Guarantee and Complaint of the BISON-CHUCKS
Company Ltd. Products – are given in the www.bison-chucks.pl