14
Tear off the Velcro tape of the tank head belt.
6
Remove the regulator first stage from the tank.
2
3
Loosen the tank belt, and remove the B. C. from upside
of the tank.
7
Close a tank valve, release the residual pressure inside
of a hose by pushing the purge button of regulator
second stage, and then disconnect the B. C. hose from
a nose. (Refer to page 7)
1
When you move the base of the tank buckle toward the
direction of arrow, belt will be loosened.
5
Tear off the end of tank belt from a Velcro tape, and turn
the buckle.
Draw a belt through the slot of the tank buckle.
4
Warning
●When you remove a B. C. from a tank, please put the tank on the
stable place, such as the flat ground. It is dangerous if it falls.
【
Note
】
●Keep it in the state that a belt is not drawn from a tank
buckle even after removing from B. C., it will make you
easy for next setting.
Tank Buckle
How to Remove a B. C. from a Tank
REMOVE B.C. FROM TANK
Wash Outside
After soaking the whole equipment to fresh water for
about 15 minutes, rinse the whole in water to wash the
salt away.
1
Wash Inside a Float
While pushing “ORAL” button of
inflator, press a faucet of water
service against a mouthpiece
portion, and put fresh water in
float about 1/4.
1
WASH & DRY
Wash away each valve and inflator portion with fresh
water well.
2
Open a tank valve, push “OUT”
button 4
～
5 times. Water inside a
valve will be drained from the
base of the “OUT” button.
Install regulator first stage to a tank, and connect the
B. C. hose to an inflator.
Hold B. C. so that the housing
position of the base of an inflator
hose may become the bottom, and
also make an inflator position to
the bottom, and drain the water
inside of the float with air by
pushing the “ORAL” button.
4
After blowing air from the mouthpiece of an inflator to
inflate B. C., shake the B. C. fully, and rinse the inside of
float.
2
3
Wash Inside of a Valve.
Repeat the above 1
～
3 process
for 2 to 3 times.
2
3
Wash inside of a float.
1
Caution
●Please do not push water out of the relief valve by using
the pressure while putting air into B. C. It causes the
damage.
Caution
●Equipment may be damaged if soaked in hot water of 50
℃
or more.
●Please wash B. C. with fresh water immediately after use.
If the salt attached dries and crystallizes, it causes an
operation failure of a valve.